Enduro Engineering Replacement Rear Disc Guard Shark Fin

Enduro Engineering Replacement Rear Disc Guard Shark Fin

This product is a replacement shark fin for the Enduro Engineering Rear Brake Disc Guard.

Installation Instructions:

1. Remove the rear wheel from the bike.
2. Slide the caliper carrier off the swing arm.
3. Using a 4mm allen wrench, remove the 3 bolts on the disc guard fin. This can be done by removing the caliper or leaving it on.
4. Pull off the old fin from the carrier.
5. Slide the new fin in place of the old fin, lining up the three mounting holes.
6. Insert the new bolts into the three mounting holes.
7. Tighten using a 4mm allen wrench.
8. Reinstall the carrier back on the swingarm and reinstall the rear wheel.

Weighing 0.23 kg and with dimensions of 0.1524 x 0.1016 x 0.0254 m, this replacement shark fin is a crucial part for maintaining the performance and protection of your Enduro Engineering Rear Brake Disc Guard.